D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
8-28 Section 8-2 - Covers - Replacement Procedures
PRELIMINARY
8-2-12-5 Rear Folder Box Installation Procedure
1) Peel off the protective strip from the adhesive pad located on the rear of the folder box
(shown in Figure 8-27) to expose the adhesive surface.
2) Holding the rear folder box with both hands, carefully align it against the rear of the support column,
then push it downwards to secure the two plastic hooks onto the two supporting pins located each
side of the support column- refer to Figure 8-26.
3.) Make sure the folder box is correctly positioned then push the adhesive pad against the column to
firmly fix the box in position - see Figure 8-28.
Figure 8-27 Rear Folder Box - Adhesive Pad at Rear
Figure 8-28 Rear Folder Box Installed on Vivid™ S60/Vivid™ S70Support Column
THE FOLDER BOX HAS A MAXIMUM CARRYING CAPACITY OF 2 KGS.
DO NOT EXCEED THIS LIMIT!
Adhesive Pad
Protective Strip
To Next Page
Loading...
