GE Vivid S70N - Black and White Printer Replacement Procedure; Time Required

D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-187
PRELIMINARY
8-8-2 Black and White Printer Replacement Procedure
NOTE: This section describes removal and replacement procedures only.
For initial installation and configuration instructions, refer to the information provided in
Chapter 3 -System Setup.
NOTE: When replacing the Black and White Printer, make sure the correct cover kit has been ordered, if
applicable. Refer to Chapter 9 -Renewal Parts for details.
8-8-2-1 Tools
Use the appropriate screwdrivers as indicated in the Black and White Printer replacement procedure.
8-8-2-2 Time Required
30 minutes
8-8-2-3 Preparations
Shut down the Vivid™ S60/Vivid™ S70 ultrasound unit, as described in Power Shut Down on page 4 - 7.
8-8-2-4 Black and White Printer Removal Procedure
1) Remove the following covers: left side, right side, front, AC Distribution Box:
2.) Loosen the two lower Phillips screws on either side of the Peripherals Console (that secures the
Black and White Printer in position), as indicated in Figure 8-213.
Figure 8-212 Black and White Printer
FRU Part #
Refer to Table 9-24 on page 9-24.
• Air Inlet (Left Side) Cover Removal Procedure on page 8 - 7
• Right Side Cover Removal Procedure on page 8 - 10
• Front Cover Removal Procedure on page 8 - 16
• AC Distribution Box Cover Removal Procedure on page 8 - 29