GE Voluson P6 BT18 - 3-5-6 Connecting the Footswitch

GE RAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
3-20 Section 3-5 - Connection of Auxiliary Devices
3-5-6 Connecting the Footswitch
The footswitch should be directly connected to any accessible USB-port on the Voluson™ P8/
Voluson™P6 (e.g., on rear of the system).
NOTE: Connection of the Footswitch is always the same.
After physical connection, adjust the Footswitch (Left/Right) as described in Section 3-8-1-6 "How to
adjust function of the Footswitch (Left/Middle/Right)" on page 3-59.
Figure 3-10 Footswitch connection scheme