GE Vscan Air - Page 90

Preparing Vscan Air CL for Use
3-22 Vscan Air – User Manual
Direction GP092020-1EN
Rev 18
Vscan Air CL is charging
The Vscan Air CL probe will be powered off during charging.
Please refer ‘How to charge the Vscan Air CL’ on page 3-2.
Figure 3-11. LED states when Vscan Air CL is charging
- A blinking li
ght on both LEDs indicates a Vscan Air CL
charging issue.
- A st
eady orange/red toned yellow on both LEDs indicates
the Vscan Air CL is charging. Charge level is less than 8%, and
probe will need to charge above this level to be powered on.
- A st
eady yellow light on both LEDs indicates the Vscan Air
CL is charging. Charge level in the range 8-90%.
- A
st
eady green light on both LEDs indicates the Vscan Air CL
is charging. Charge level 90-100%.
The Vscan Air CL probe will when removed from the charge pad
keep the LED lights light for 5-10 seconds before turning them
off, leaving the probe powered OFF.
1. Battery level <8%
2.
Battery level 8-90%
3. Fully
charged