GE WSSH300G User Manual

31
Releasing the bellows (door boot) from the
front panel:
The front of the bellows is installed over the lip of the
door opening in the front panel and held in place by a
spring loaded wire loop.
1. Open the loading door.
2. Using needle nose pliers, start where the spring
and wire are connected at the bottom of the
bellows and pull the wire out of the groove of the
bellows.
3. Pull the bellows off of the lip of the front panel.
Removing the door safety switch:
1. Disconnect the washer from the electrical supply.
2. Release the bellows from the front panel.
3. Remove the (2) screws holding the switch
assembly to the front panel.

GE WSSH300G Specifications

General

Brand	GE
Model	WSSH300G
Category	Washer
Language	English