GE WSSH300G - Removing the Hose between the Drain Pump and the Drain Hose Coupler

47
2. Release the clamp and slide the hose off the drain
pump.
3. Release the clamp and slide the hose off the
drain hose coupler.
5. Release the hose from it’s guides and pull the
hose out.
2. Loosen the clamp at the tub.
an
3. Release the clamp at the pump.
4. Slide the hose off of the tub and pump to remove
the sump.
Removing the hose between the drain
pump and the drain hose coupler:
1. Disconnect the washer from the electrical supply,
remove the top panel and the front access panel.
Note: There will be water in the pump and hose.