6
Resistance Ω
Electrical component @ 77°F (25°C)
Dispenser valve solenoids 800 ± 7%
Door lock solenoid 1325 ± 10%
Pump motor 12 ± 7%
NTC thermistor 3K - 163K
M1 TO M2 5.3 ± 7%
M2 TO M3 5.3 ± 7%
M1 TO M3 5.3 ± 7%
M4 TO M5 118 ± 7%
QUICK REFERENCE SHEET
Component resistance chart.
Water level
Water fill height 4 ± .5 “
No load, start position of permanent press cycle.
Electrical requirements.
Incoming water pressure.
Drain requirements.
Motor.
Circuit - Individual, properly polarized and grounded
15 amp. branch circuit fused with 15 amp. time
delay fuse or circuit breaker.
30 and 120 pounds per square inch (maximum
unbalance pressure, hot vs. cold, 10 psi.)
Drain capable of eliminating 17 gals (64.3 L) per
minute.
A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
The standpipe height above the floor should be:
Minimum height: 24 in. (61 cm)
Maximum height: 96 in. (244 cm)
Motor
No load agitate wattage - Max 150
No load spin wattage - Max 550
To Next Page
Loading...
Need help?
General
