9
Case Designation Description Details Action
12 KIN KINETIC protection status Should be OFF on normal
situation�
If ON, possible causes:
If a FLO error message,
go to FLO section
KINETIC state: No flow detected
for more than 2 hours�
All outputs including heater are
deactivated until the next flow
check 2 hours later�
Then if the controller succeeds in
flow checking, the Kinetic error will
disappear�
Reboot the controller and wait the FLO
status update�
If the FLO LED is OFF, go to case #11�
If the FLO LED is ON, proceed to the
normal maintenance, filters cleaning���
Keep in mind that the Kinetic error
could happen again, it is really rare to
get an intermittent Kinetic error�
Flashing: internal communication n/a
Issue on spa control
(e�g� FLO and KIN LEDs are ON
at the same time)
Replace the spa control
13 D10 Light & RGB cmd status Is ON only when the Light is
turned ON by the user, and OFF
otherwise�
If not possible causes:
No POWER Go to case #1
Case Designation Description Details Action
14 D101 Relay (K26) cmd status
* Please note that the relay
is included on the PCB
EXT-IR which is optional.
Should always be turned on
when the accessory is on�
(Refer to the accessory
configuration documentation)
If turned on and the accessory
isn’t working:
Connection of accessory problem Check the connection of the accessory
F23 burnt Check F23
If turned off and the accessory
is working:
Issue on relay K26 Change the in�EXT-1R board
Troubleshooting
Option EXT-1R
D101
To Next Page
Loading...
Need help?
General
