12
For the in�yj control
systems:
• Verify that the
heat�wav low voltage
cable is correctly
plugged into the
probe connector (P1)�
If the measured temperature is below 119 °F (48°C) and the water heater’s body is not hot:
Probe connector
(heat�wav low voltage cable)
Regulation and overheat
captor probe
Troubleshooting
Regulation and overheat
captor probe
For the in�ye, in�yt and in�xe control systems:
• Verify that the regulation and overheat captor are plugged in correctly�
• Turn the spa off and turn it back on to reinitialise the system�
• If error HL persists replace the water heater�
• If error HL persists replace the control system�
in.yj
in.yjin.yj-re
in.ye and in.yt in.xe
If the measured temperature is 119 °F (48°C) or above and does not correspond to the one displayed on the keypad:
For the in�ye, in�yt and in�xe control systems:
• Verify that the regulation and overheat captor are plugged in correctly�
• If the cable is correctly plugged in, replace the water heater�
• Turn the spa off and turn it back on to reinitialise the system�
• If error HL persists replace the control system�
For the in�yj
control systems:
• Verify that the
heat�wav low voltage
cable is correctly
plugged into the probe
connector (P1)�
Probe connector
(heat�wav low voltage cable)
Probe connector (regulation
and overheat captor)
in.ye-V3
Regulation and overheat
captor probe
Regulation and overheat
captor probe
Regulation and overheat
captor probe
in.ye-V3 in.ye and in.yt in.xe
Regulation and overheat
captor probe
For the in�yj-re control
systems:
• Verify that the probe is
correctly plugged into
the probe connector
(P40)�
• If the cable is correctly
plugged in, replace the
probe�
• Turn the spa off and
turn it back on to
reinitialise the system�
• If error HL persists
replace the control
system�
To Next Page
Loading...
Need help?
General
