EasyManua.ls Logo

gefran QE1008-W SET - 10.4.1. Activating the system

gefran QE1008-W SET
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
Subject to technical modications
10.4.1. Activating the system
First use of sensors
Before using the QE1008-W sensors for the rst time, make sure that the supplied
display software is installed on the computer.
Use the Sensormate App if on your PC is installed Windows 10.
(see section: „Sensormate App“)
Use the Inspectmate Software if on your PC is installed Windows XP/7/8/10.
(install the Inspectmate Software from USB-Stick)
Activating the system
1. Switch on all sensor pairs.
→ Press the button on the housing for 1 second.
→ The LED ash green.
2. Connect the wireless receiver to the USB port of the PC.
3. Start the display software on the PC.
The wireless receiver automatically connects
to all activated QE1008-W sensors.
If the wireless receiver is recognised by the
software, this is conrmed by "QE1008-W" in
the information display.

Related product manuals