Gemmy PLC-01 - Centrifuge Disassembly Guide

DISASSEMBLY:
WARNING
：
For sake of safety, the disassembly must be done the qualified
personnel or licensed engineers only. GEMMY will not ensure the
responsibility if user violates this regulation.
 Remove the bottom plate by loosening the set-screw.
 Loosen the nuts from rubber supports attached to the base to
remove the rack of motor
 Unscrew the motor from the rack
 Disconnect wires from assembly prior to disassemble the
electronic parts.
 Loosen the bolt to remove the rotor.
 Remove the control knobs of timer and speed regulator by
loosening the screws on it.
 The front control panel is glued.
 Unscrew the set bolts to remove timer and speed regulator.
 Loosen screws for chamber removal.
 Always disconnect from power supply prior to disassembly.
WARNING
：
- Disconnect from power supply prior to disassembly of this
equipment.
- People other than the qualified personnel or licensed engineers
are strictly prohibited for disassembly.
9