HOW TO INSTALL TESTING TUBES
The balance of rotor has been well calibrated in house thoroughly
before delivery, the user is again requested to install the testing tubes
in the correct way carefully prior to spinning this centrifuge as depicted
below:
1. Place the testing tubes into the tube adaptors diagonally and
symmetrically to balance the rotor. Please refer to the figure.
2. Place the testing tubes gathering on one single side will create
imbalance of rotor, which will possibly cause vibration of rotor.
3. If odd number of testing tube is used, supplement another dummy
tube to remedy the problem.
5
To Next Page
Loading...
