.
To program an alternate or "Special Day" program, that you can access at any
time, press day> until PROGRAM for SPD day is displayed. Repeat
the procedure above to program temp settings for the Special Day.
When finished programming, press HOME to save your program.
.
To program for cooling,
select COOL with the Heat/Cool MODE switch and repeat the above procedure.
.
To REVIEW the program you have entered.
Press PROGRAM once to enter Programming Mode.
Then, press FILTER / REVIEW once,
The display will cycle through the programmed times and temps, showing each
program for 12 seconds. Starting from Sunday; MORN and ending
at Saturday; NITE.
The programmed temperature is shown on the left of the LCD, the programmed
time, day and time slot are shown on the right and right top of the LCD
respectively.
3 Program cont.
DAY
PG 6
To Next Page
Loading...
