514
22/28
12 Removal and disposal
Preparation for all work
(refer to chapter 1.3)
1. Decontaminate the plant (or plant compo-
nent) expertly, wash it out and ventilate it.
2. Loosen the connections according to
body type.
3. Remove welded-in valves from the
piping using appropriate means.
4. Disassemble the valve carefully.
13 Reselling
If reselling used valves, inform GEMÜ. If
used valves are sold, the manufacturer's
guarantee and liability expire.
The purchaser must be informed of the
installation and use of the valve to date with
respect to media, media concentration,
pressure, temperature and ambient condi-
tions.
14 Returns
Returns must always be made with a decla-
ration of return (copy specimen enclosed or
download from www.gemue.de).
If not completed, GEMÜ cannot process
- credits
- repair work
and only provide disposal at the operator's
expense.
IMPORTANT
Legal regulations for protection of the
environment and employees make it
necessary to enclose this declaration
fully filled out and signed together with
the dispatch documents. Your return
will only be processed if this declaration
is completely filled out!
ATTENTION
Valve parts that are contaminated by
media must be disposed of according to
relevant local or national disposal regu-
lations / environmental protection laws.
Pay attention to adhered residual material
and gas diffusion from penetrated media.
Should there be any doubts or misunder-
standings in the preceding text, the German
version of this document is the authoritative
document!
Note on staff training
Please contact us at the address below
for staff training information.
Note concerning the EC Machinery
Directive 2006/42/EC:
A Declaration of Incorporation in accor-
dance with the EC Machinery Directive
2006/42/EC accompanies this product.
For incorporation in an installation
classed as a machine:
The commissioning is prohibited until it
has been determined that the machine
(plant) in which this product is to be incor-
porated complies with the provisions of
the EC Machinery Directive 2006/42/EC.
Handling, assembly and commissioning,
in addition to setting and adjustment of
the machine must be performed only by
authorised specialist staff.
15 Information
To Next Page
Loading...
