RXC-3000 Hardware Installation and User Guide
9000-0000-040 Revision 10 16 of 46 Genave Electronics
DC Wiring
The installer can choose to power the RXC-3000 from a +12 Volts DC power
source that can supply a minimum of 3 amps. The connector type is a Tyco 3-
640427-2 IDC connector. It has a pin spacing of 0.156 inches and is made for
20 AWG wire. A special tool is required to make connections. Alternatively,
Genave can make a custom length cable for installation.
Warning: Make certain that the polarity of the wires is correct. Even though the unit has diode
protection for reverse voltages, damage to the RXC-3000 may occur if the polarity is reversed.
Battery Backup
The battery backup consists of a seven amp hour sealed lead acid battery along with a universal input
battery charger. Input voltage for the charger can range between 100 – 240 Volts AC.
To Next Page
Loading...