RXC-3000 Hardware Installation and User Guide
9000-0000-040 Revision 10 23 of 46 Genave Electronics
Output Header Pinout (Aux Output)(J5)
The first 5 pins of the Aux output header are connected to the
5 on board relays. When they are off, the outputs will be
+12VDC. When the transistors are on, the output will be 0
VDC. Do not connect these pins to any voltage higher than
+12VDC since the voltage will go through the relays and into
the RXC-3000's power supply.
Pin 1 - Relay #1
Pin 2 - Relay #2
Pin 3 - Relay #3
Pin 4 - Relay #4
Pin 5 - Relay #5
Pin 6 - Uncommitted Transistor
Pin 7 - Uncommitted Transistor
Pin 8 - Uncommitted Transistor
Pin 9 - Ground
Output Header Transistor Characteristics
Pins 6,7,8 are connected to the collectors of 3 uncommitted transistors. Each transistor can handle a
maximum of 30VDC and 150mA. When activated, the transistors pull the pins to ground (pin 9).
To Next Page
Loading...