RXC-3000 Hardware Installation and User Guide
9000-0000-040 Revision 10 22 of 46 Genave Electronics
Outputs
Relay Characteristics
The RXC-3000 has 5 high power relays available for use. Each relay can handle 240VAC at 7 Amps.
Each relay's outputs are directly connected to a 3 position header (J6 to J10) that can accept wires up to
12 AWG diameter.
Each output connector is a “1 FormC” output (A single switch with normally open, common and
normally closed connections).
The relay is supplied on one side of its coil with +12VDC and the other side of the coil controlled by a
transistor that, when active, pulls the relay's coil to ground and activates the relay.
The transistors that control the relays are also connected to the output header along with 3
uncommitted transistors. (see below).
To Next Page
Loading...