RXC-3000 Hardware Installation and User Guide
9000-0000-040 Revision 10 19 of 46 Genave Electronics
Inputs
Input Header Characteristics (J14 and J15)
The inputs for the RXC-3000 are ALWAYS pulled low to pin 9 of J14 or J15. You can connect these
inputs to switches or opto-couplers. We recommend that they are not connected directly to a digital
level source unless there is protection between the two circuits.
Never supply voltage to these inputs. Even though they are protected with diodes in case a voltage
above +5VDC is applied to them, they may become damaged. Each input has a pull up resistor.
Input header J14 is used to add additional remote switches to the RXC-3000.
Input header J15 is for future use with sensors
designed for the RXC-3000.
Optional spring cage clamp
connector Part 6000-0101-124
To Next Page
Loading...