Generac Power Systems 1292-1 User Manual

15
 Remove additional debris by back flushing water
through wand extension (Figure 18). Back flush
between 30 to 60 seconds. Turn nozzle
extension to stream spray and move nozzle
forward and backward while flushing.
 Reinstall nozzle into the wand extension. DO
NOT overtighten.
 Reconnect the nozzle extension to the spray
gun.
 Reconnect the water supply, turn on the water,
and start the engine.
 Test the pressure washer by operating with
nozzle in the high and in the low position.
Engine Maintenance
See the engine owners manual for instructions on
how to properly maintain the engine.
Service and Adjustments
See the engine owners manual for instructions on
how to properly service and adjust the engine.
PREPARING THE UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and freeze pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1. Flush chemical injection tube by placing the
injector filter into a pail of clean water while
running pressure washer and squeezing the
spray gun trigger with the adjustable nozzle in
low pressure mode. Flush for two minutes.
2. Shut off the engine and let it cool, then remove
all hoses.
3. Place throttle lever in STOP position.
CAUTION! Be sure throttle lever is in STOP
position before you continue. If you start
engine without proper water supply
connected, you can damage the pump.
4. Empty the pump of all pumped liquids by pulling
recoil handle about 6 times. This should remove
most of the liquid in the pump.
NOTE: To protect unit from freezing temperatures,
pour RV Antifreeze fluid (antifreeze without any
alcohol) into a 3-foot section of garden hose
connected to inlet adapter and pulling recoil handle
twice.
5. Store in a clean, dry area.
Storing the Engine
Using a fuel additive such as STA-BIL®, or
equivalent, will prevent the build up of gum and
varnish in the fuel system. Refer to the engine
owners manual for further information.
Figure 18  Backflush nozzle.
Generac Portable Products 2300PSI High Pressure Washer

Generac Power Systems 1292-1 Specifications

General

Brand	Generac Power Systems
Model	1292-1
Category	Pressure Washer
Language	English