The manufacturer recommends fresh, clean unleaded
automotive gasoline with a minimum of 87 octane.
Use clean fuel and store in approved, clean,
covered containers. Use clean fill funnels. Never
use stale gasoline left over from last season or
gasoline stored for long periods (over 30 days).
Clean area around fuel fill cap, remove cap.
(Figure 6).
Add UNLEADED regular gasoline, slowly, to
fuel tank. Use a funnel to prevent spillage.
Install fuel cap and wipe up any spilled gasoline.
Note: Some fuels, called oxygenated or reformulated
gasolines, are gasoline blended with alcohols or
ethers. Excessive amounts of these blends can
damage the fuel system or cause performance
problems. If any undesirable operating systems
occur, use gasoline with a lower percentage of
alcohol or ether.
Connect Hose and Water Supply to Pump
IMPORTANT: You must assemble the nozzle
extension and attach all hoses before you start the
engine. Starting engine without all hoses connected
and water supplied will damage pump.
Uncoil high pressure hose and attach hose quick
connect coupler to the fitting on the spray gun
(Figure 7). To engage the fitting, pull back on the
coupler collar, insert the gun fitting, and release
the collar. Pull on the gun to make sure it is
securely in place.
Similarly, attach other end of the high pressure
hose to the high pressure quick connect fitting
on the pump (Figure 8). Pull on the hose to
make sure it is securely attached to the pump.
8
Figure 8 Connect high pressure hose to pump.
Figure 7 Connect high pressure hose
to spray gun.
Figure 6 Add gasoline to fuel tank.
Fuel Cap
Connect High Pressure
Hose Here
Coupler Collar
Connect High Pressure
Hose Here
Generac Portable Products 2300PSI High Pressure Washer
To Next Page
Loading...
Need help?
General
