9
WARNING! You must provide a water supply
with a minimum flow of 3.2 gallons per minute
or damage to the pump will occur.
Before you connect your garden hose to the
water inlet, inspect the Inlet Screen (see Figure
9). Clean the screen if it contains debris or have
it replaced if damaged. Do not run the pressure
washer if the inlet screen is damaged.
Connect garden hose to water inlet. Tighten by
hand (Figure 9).
Turn ON the water (open valve completely).
Squeeze trigger on gun to purge pump system of
air and impurities.
CAUTION! Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
Attach nozzle extension to spray gun. Tighten by
hand (Figure 10).
CHECKLIST BEFORE STARTING
ENGINE
If you have reached this point, look back over the
assembly to see if you have performed all of the
following.
Check for properly tightened hose connections
(high pressure and water supply) and for tight
connections and that there are no kinks, cuts, or
damage to the high pressure hose.
Check that oil has been added to proper level in
engine crankcase before trying to start the
pressure washer.
Add proper gasoline to fuel tank.
Provide proper water supply (not to exceed
140°F).
Be sure to read Safety Rules and Operation
sections before using the pressure washer.
Figure 10 Connect nozzle extension
to spray gun.
Figure 9 Connect garden hose to water inlet and
turn ON the water.
Check Screen for Damage
Generac Portable Products 2300PSI High Pressure Washer
To Next Page
Loading...
Need help?
General
