EasyManuals Logo

Generac Power Systems 1292-1 User Manual

Generac Power Systems 1292-1
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
Never allow any part of the body to come in
contact with the fluid stream. DO NOT come in
contact with a fluid stream created by a leak in
the high pressure hose.
The high pressure hose can develop leaks from
wear, kinking, abuse, etc. Water spraying from a
leak is capable of injecting material into
skin. Inspect the hose each time before use.
Check all hoses for cuts, leaks, abrasions or
bulging of cover, or damage or movement of
couplings. If any of these conditions exist,
replace hose immediately. Never repair the high
pressure hose. Replace it with another hose that
meets minimum pressure rating of your pressure
washer.
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury.
Always wear eye protection when you use this
equipment or when you are in the vicinity where
the equipment is in use.
Never move the machine by pulling on the high
pressure hose. Use the handle provided on the
top of the unit.
Always be certain the spray gun, nozzles and
accessories are correctly attached.
Never use a spray gun which does not have a
trigger lock or trigger guard in place and in
working order.
Use a respirator or mask whenever there is a
chance that vapors may be inhaled. Read all
instructions with mask so you are certain the
mask will provide the necessary protection
against inhaling harmful vapors.
High pressure spray may damage fragile items
including glass. Do not point spray gun at glass
when in high pressure mode.
Keep the hose connected to machine and spray
gun while the system is pressurized.
Disconnecting the hose while the unit is
pressurized is dangerous.
Hold the spray gun firmly in your hands before
you start the unit. Failure to do so could result in
an injury from a whipping spray gun. Do not
leave the spray gun unattended while the
machine is running.
The cleaning area should have adequate slopes
and drainage to reduce the possibility of a fall
due to slippery surfaces.
Keep water spray away from electric wiring.
Fatal electric shock may result.
Do not secure trigger gun in the pull-back (open)
position.
Do not by-pass any safety device on this
machine.
The muffler and engine heat up during operation
and remain hot immediately after shutting it
down. Avoid contact with a hot muffler or engine.
Operate and store this unit on a stable, level
surface.
Generac Portable Products 2300PSI High Pressure Washer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems 1292-1 and is the answer not in the manual?

Generac Power Systems 1292-1 Specifications

General IconGeneral
BrandGenerac Power Systems
Model1292-1
CategoryPressure Washer
LanguageEnglish

Related product manuals