Maintenance
22 Owner’s Manual for 60 Hz EcoGen™ Generator
Maintenance Log
Battery inspection and charge check
Dates Performed:
Oil, oil filter, air filter and spark plug replacement
Dates Performed:
Valve Adjustment
Dates Performed:
Check Enclosure Louvers
1. Verify that intake and exhaust louvers and
openings are clean and unobstructed.
2. Wipe exterior surfaces clean using a damp cloth.
3. Loosen dirt, oil, etc. with a soft bristle brush.
4. Remove loose dirt and debris using a vacuum
cleaner, or low pressure compressed air (not
exceeding 25 psi [172 kPa]).
NOTE: Periodically wash and wax enclosure using
automotive type products. Frequent washing is
recommended in salt water/coastal areas.
Check Lines and Connections
Perform a general inspection as follows:
• Check Fuel Lines and Connections for Leaks
• Check Oil Lines and Connections for Leaks
To Next Page
Loading...
