Generac Power Systems Guardian 5410 User Manual

Section 9
Exploded Views
Page 71
ITEM QTY. DESCRIPTION
1 1 FraME
3 1 ENGINE WraPPEr, StartEr SIDE
4 8 SCrEW HHFC M8-1.25 X 14
5 1 SNaP BUSHING
6 14 SCrEW CrIMPtItE 10-24 X 1/2
7 1 SHIELD WraPPEr, CYLINDEr #1
8 13 SCrEW HHFC M6-1.0 X 12 G8.8
9 1 ENGINE WraPPEr, BaCK
10 1 BaCKPLatE
11 1 aSSY, FLYWHEEL & rING GEar 29D
12 1 aSSY, GrOUND WIrE CONNECtOr
13 1 WaSHEr,BELV-20 X 2.2
14 1 NUt HEX M20-1.5 G8
15 1 BLOWEr HOUSING
16 1 SHIELD WraPPEr, CYLINDEr #2
17 1 KEY, WOODrUFF 4 X 19D
18 1 BrEatHEr HOSE
19 3 WaSHEr FLat 3/8 – M10 ZINC
20 1 IGNItION COIL CYLINDEr #1
21 1 IGNItION COIL CYLINDEr #2
22 4 SCrEW HHFC M6-1.0 X 25 SEMS
23 2 GaSKEt, INtaKE
24 1 INtaKE MaNIFOLD
25 4 SCrEW SHC M8-1.25 X 20 G12.9
26 1 GaSKEt, MaNIFOLD tO CarB/MIXEr
27 1 CarBUrEtOr
28 1 rOD, CHOKE CONtrOL
29 1 aSSY GOVErNOr rOD
30 1 GaSKEt, aIrBOX/CarB
31 1 CLaMP, HOSE OEtIKEr StEPLESS 14.5
32 1 WraPPEr, ENGINE OIL aDaPtOr
33 1 SNOrKEL, aIr BOX
34 1 aIrBOX BaSE
35 1 aIr FILtEr
36 1 aIrBOX SEaL
37 1 aIrBOX QUartEr KNOB
38 1 aIrBOX COVEr
40 1 OIL DraIN LINE
41 4 SCrEW HHtt M6-1.0 X 10 YELLOW CHrOME
42 1 CLaMP, VINYL 9.5 O.D.
43 2 3/4 NPt tO 3/8 O.D. FLarE
44 1 aSSY, CaP aND DIPStICK
45 1 OIL DraIN/DIPStICK tUBE
46 1 90 DEGrEE ELBOW 3/8 NPt X 3/8 BarBED
47 2 HOSE OEtIKEr CLaMP
48 8” HOSE, 3/8” I.D.
ITEM QTY. DESCRIPTION
49 1 aSSY, OIL DraIN FIttING
50 1 OIL FILtEr SUPPOrt
51 2 SCrEW SWaGE 1/4-20 X 1
52 1 OIL FILtEr
53 1 OIL PrESSUrE SWItCH 5 PSI
54 1 SWItCH, tHErMaL 270F
55 2 WaSHEr, LOCK M3
56 2 SCrEW PPHM M3-0.5 X 8
58 1 BraCKEt, OIL CHECK tUBE
59 1 SCrEW SWaGE 1/4-20 X 1/2
60 1 WraPPEr ENGINE VaLLEY
61 1 WraPPEr UPPEr VaLLEY
62 1 WraPPEr INNEr CYLINDEr #2
63 1 WraPPEr INNEr CYLINDEr #1
64 2 SParKPLUG
65 1 OIL LINE OUt
66 1 OIL LINE IN
67 2 SCrEW PPHM #4-40 X 1/4
68 1 aSSEMBLY, BI-MEtaL/HEatEr
69 1 CHOKE SOLENOID
70 1 CONtrOLLEr aSSEMBLY
71 2 SCrEW HHC M6-1.0 X 10 G8.8
72 6 WaSHEr LOCK M6-1/4
73 1 BaLL StUD, 10 MM
74 1 NUt HEX LOCK M3-0.5
75 1 BraCKEt, CONtrOLLEr SUPPOrt
76 2 SCrEW HHC M6-1.0 X 12 G8.8
77 1 aSSY, GrOUNDING WIrE W/O DIODES
78 1 COttEr PIN
80 1 BOOt, Batt. CaBLE
81 1 WIrE aSSY. Batt. POS.
83 2 WaSHEr, FLat 1/4-M6
84 2 SCrEW HHC M8-1.25 X 85
85 2 NUt M6-1.0
86 2 SCrEW CrIMPtItE 10-24 X 3/8
87 1 Start MOtOr
88 2 WaSHEr, LOCK M8-5/16
89 1 WaSHEr, LOCK SPECIaL 3/8
90 4 SCrEW HHC 3/8-16 X 1-3/4
91 1 CLaMP VINYL .75 X .343
92 1 INSULatOr
93 1 GaSKEt, MaNIFOLD tO CarB/MIXEr
94 2 BOLt,CarB MOUNt M6-1.0 X 95
95 2 StUD M6-1.0 X 100
96 3 WaSHEr LOCK M10
97 1 HOSE, EVaP. POrt

Generac Power Systems Guardian 5410 Specifications

General

Brand	Generac Power Systems
Model	Guardian 5410
Category	Inverter
Language	English