Generac Power Systems PROTECTOR RG048 - Preparing Generator (New Installations)

Submitted by NW Electrical
Job Name:
Self-Reliance Credit Union
Catalog Number:
7170
Notes: Usual lead time prox 2-3 weeks ARO
Type:
--
NWES24-21067
Installation and Operation
Installation and Users Manual for Mobile Link
®
9
Preparing Generator (New Installations)
1. Unlock both locks, open generator lid, and
remove front panel.
2. See Figure 4-4. If generator is equipped
with an internal breaker near the control-
ler, remove end panel from right side. Oth-
erwise, proceed to Step 3.
Figure 4-4. Removing End Panel
(Internal Breaker)
3. Turn generator OFF. Remove generator
panel fuse.
NOTE: There are different controller configu-
rations for various model years.
4. Turn main utility disconnect breaker in
homes electrical panel to OFF or OPEN.
5. Using an appropriate fuse puller, remove
T1 fuse from transfer switch.
6. Disconnect negative () battery cable,
then positive (+) battery cable.
7. If generator is equipped with an external
breaker box, remove controller sheet
metal cover and fasteners.
8. See Figure 4-5. 2013 and later models
have a pre-positioned dimple on the end
panel. The dimple marks the center of the
mounting hole to be drilled.
Figure 4-5. Pre-Positioned Dimple
9. Inspect area behind external breaker box
to verify all wires are moved out of the way
to prevent damage during drilling.
IMPORTANT NOTE: Cover the breaker box
prior to drilling to prevent metal shavings
from entering breaker box.
NOTE: Models equipped with an internal
breaker mounted near the controller will
already have the end panel removed at this
point. Carefully place the end panel face up on
a clean, smooth, flat surface to avoid damag-
ing the paint.
10. Drill a 1-1/8 in (29 mm) diameter hole with
the dimple as the center point.
11. Proceed to Connecting New Mobile Link
Unit.
Index Page