Generac Power Systems PROTECTOR RG048 - Preparing Generator (Equipped with Existing Mobile Link Unit); Connecting New Mobile Link Unit

Submitted by NW Electrical
Job Name:
Self-Reliance Credit Union
Catalog Number:
7170
Notes: Usual lead time prox 2-3 weeks ARO
Type:
--
NWES24-21067
Installation and Operation
10 Installation and Users Manual for Mobile Link
®
Preparing Generator (Equipped with
Existing Mobile Link Unit)
1. Unlock both locks, open generator lid, and
remove front panel.
2. See Figure 4-6. If generator is equipped
with an internal breaker near the control-
ler, remove end panel from right side. Oth-
erwise, proceed to Step 3.
Figure 4-6. Removing End Panel
(Internal Breaker)
3. Turn generator OFF. Remove generator
panel fuse.
NOTE: There are different controller con-
figurations for various model years.
4. Set utility MLCB on homes electrical panel
to OFF (OPEN).
5. Using an appropriate fuse puller, remove
T1 fuse from transfer switch.
6. Disconnect negative () battery cable,
then positive (+) battery cable.
7. Disconnect wire harness from Mobile Link
Wi-Fi/Ethernet device.
8. Unscrew, remove, and discard old Mobile
Link Wi-Fi/Ethernet device according to
local, state, or national laws.
9. If generator is equipped with an external
breaker box, remove controller sheet
metal cover and fasteners.
NOTE: Models equipped with an internal
breaker mounted near the controller will
already have the end panel removed at this
point. Carefully place the end panel face up on
a clean, smooth, flat surface to avoid damag-
ing the paint.
10. Proceed to Connecting New Mobile Link
Unit.
Connecting New Mobile Link Unit
1. See Figure 4-7. Push the threaded end of
the Mobile Link Wi-Fi/Ethernet device (A)
from the controller end panel from the
inside. Only the threads should show from
the outside of the enclosure.
Figure 4-7. Mobile Link Wi-Fi/Ethernet
Device Installation
2. Tighten supplied PVC nut (B) over the
exposed threaded portion of the unit and
tighten firmly.
3. Thread antenna (C) into Mobile Link Wi-Fi/
Ethernet device. Rotate antenna clock-
wise until secure. Position antenna point-
ing up.
NOTE: Do not overtighten antenna. Hand
tighten only.
4. Insert six pin harness connector from
Mobile Link Wi-Fi/Ethernet device into
mating connector of wiring harness. Con-
nector will only fit one way. DO NOT force
into place.
B
A
C
A
B
C
Index Page