Installation and Operation
Installation and Users Manual for Mobile Link
®
11
5. See Figure 4-8. With connector installed,
tighten plastic fitting to secure Wi-Fi/Ether-
net unit until tight and device is secured to
end panel.
Align antenna vertically.
Figure 4-8. Mobile Link Wi-Fi/Ethernet
Device In Place
NOTE: Hold Mobile Link Wi-Fi/Ethernet
device firmly and tighten nut during installation
to avoid damage to unit wiring harness.
6. Route wire harness to back side of control-
ler. Wherever possible, bundle harness
with other wire looms to provide additional
support.
Continue Installation Process
If this a new installation, proceed to Step 7.
If this is a retrofit installation, proceed to
Complete Unit Installation (New and Retro-
fit).
7. (New installations only): Locate acces-
sory port. Accessory port is an eight-pin
connector on underside of controller.
On models equipped with an external
breaker box, lift controller to gain
access to accessory plug location.
See Figure 4-9. On models equipped
with an internal breaker mounted near
the controller, accessory port is visible
from battery compartment when end
panel is removed.
Figure 4-9. Accessory Port (Internal
Breaker)
NOTE: If there is a decal labeled Port 1 or
Accessory Prt 1, remove decal to locate port.
8. Install eight pin connector harness into
open socket on controller.
NOTE: The connector will only fit one way. DO
NOT force.
9. For units equipped with Evolution 1.0
controllers or earlier: See Figure 4-10.
Loosen and remove nuts (A) from both
positive (+) and negative () battery termi-
nal screws on battery cables. Slide har-
ness power wires (B) over battery terminal
screws and replace nuts. Tighten securely.
Figure 4-10. Attach Harness Power Wires
NOTE: Harness power wires consist of a
black negative () wire and a fused red posi-
tive (+) wire.
10. Connect battery cables. Connect positive
battery cable first, then negative battery
cable.
B
A
To Next Page
Loading...
