CUBE
+
HYBRID 8,4m 4x150W LED
TL203-01-12-00
16-07-2018
Italiano - English
DISCOVER battery
YANMAR ENGINE
L’inverter deve rimanere sempre acceso:
verificare che il tasto “On-Off-Eco” sia sulla
posizione “On”.
The inverters have to be always turned on:
verify that the “On-Off-Eco” button is on “On”
position.
I led rosso e verde segnalano le seguenti
anomalie dell’inverter:
Red and green leds signal alarm or fault on
the inverter:
Risoluzione dei problemi
Trouble shooting
LED rosso spento
Stato OK
LED rosso ON o lampeggiante:
L'inverter è ancora acceso, ma si spegne quando le condizioni
peggiorano. Vedere la tabella dei LED rossi per motivi di avviso.
Red LED off
Status OK
Red LED ON or blinking:
The Inverter is stil on, but will shut down when the condition getsworse.
See red LED table for warning reason.
• • - - - - - -
Singolo impulso lento
Se l'inverter continua ad accendersi e spegnersi mentre è
collegato un carico, il carico potrebbe essere troppo piccolo
rispetto alle impostazioni della modalità ECO effettiva. Aumentare
il carico o caricare le impostazioni della modalità ECO.
(impostazione della modalità ECO minima: 15W.
• • - - - - - -
Slow single pulse
If the inverter keeps switching on and off while there is a load connected,
the load may be too small compared to the actual ECO mode settings.
Increase the load or charge ECO mode settings. (minimum ECO mode
setting: 15W.
• - • - - - - -
Doppio impulso veloce
L'inverter si è spento a causa di una protezione. L'inverter si ripristinerà
automaticamente non appena tutte le condizioni di allarme saranno state
cancellate. Vedere lo stato del LED rosso per il motivo dell'arresto.
• - • - - - - -
Fast double pulse
Inverter did shut down because of a protection. The inverter will restant
automatically as soon as all alarm conditions are cleared. See red LED
state for the shutdown reason.
LED rosso Off
Controllare l'interruttore On / Off / ECO: dovrebbe essere in posizione On
o in posizione ECO.
Controllare il connettore on / off remoto.
Controllare i collegamenti e i fusibili del cavo CC.
Fusibile dell'invertitore bruciato: l'inverter deve essere restituito per
l'assistenza.
LED rosso On lampeggiante
LED rosso acceso lampeggiante. L'inverter si è spento a causa di una
protezione. Non si riavvierà più automaticamente. Il LED rosso indica il
motivo dello spegnimento. Rimuovere la causa, quindi riavviare l'inverter
spegnendolo e quindi su On.
Red LED Off
Check the On/Off/ECO switch: it should be in On position or in ECO
position.
Check Remote on/off connector.
Check DC cable connections and fuses.
Inverter fuse blown: the inverter has to be returned for service.
Red LED On blinking
The inverter did shut down because of a protection. It will no longer
automatically restart. The red LED indicates the reason for shutdown.
Remove the cause and then restart the inverter by swiching it Off, and
then On.