CALIFORNIA PROPOSITION 65 DISCLAIMER.
Application: All 200 Series models.
T H E E N G I N E E X H AU S T A N D D U S T S / B Y -
PRODUCTS FROM THE OPERATIONAL PROCESS
OF THIS PRO D U C T C O NTAI N S C H EM I C A LS
KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER, BIRTH DEFECTS, OR OTHER
REPRODUCTIVE HARM.
SPARK ARRESTOR DISCLAIMER.
Application: All 240 Series models.
DO NOT OPERATE THE HOLE DIGGER ON ANY
FOREST COVERED, BRUSH COVERED OR
GRASS COVERED, UNIMPROVED LAND UNLESS
AN APPROVED SPARK ARRESTOR IS INSTALLED
ON THE MUFFLER. THE SPARK ARRESTOR MUST
BE MAINTAINED IN PROPER WORKING ORDER
BY THE OWNER AND/OR OPERATOR. IN THE
S TAT E O F C A L I F O R N I A , T H E A B O V E I S
REQUIRED BY LAW. OTHER STATES MAY HAVE
SIMILAR LAWS. FEDERAL LAWS WILL APPLY ON
FEDERAL LANDS. LAWS WILL VARY WITH USE IN
SPECIFIC COUNTRIES.
INFORMATION RELATIVE TO MINIMUM
COMPONENT STANDARDS FOR THE OPERATION
OF THE HOLE DIGGER.
Application: All 200 Series models.
For operational, safety and overall productivity
considerations, it is required that specific Hole Digger
components meet minimum acceptable operational
standards as follows:
1) Operator handle be properly mounted to the
transmission and be of proper structural integrity. If
cracking or deformation is detected, replace the
operator handle with a factory approved replacement
part only.
2) The twist grip throttle control be equipped with a
properly fitting handle grip of sufficient integrity to allow
for proper job function as outlined within this manual. A
loose fitting grip or a grip without a full end cap is not
permitted.
3) Throttle cable is in proper mechanical condition that
allows it to perform its intended job function as outlined
within this manual. A cable with bends, abrasions or
other damage that restricts or limits inner wire
movement must be replaced with a factory approved
replacement part only.
4) Throttle control is installed in the correct operating
position and be in a mechanical condition that allows it
to perform it intended job function as outlined within
this manual. A worn or damaged throttle control hand
grip or any other, internal part must be replaced with a
factory approved replacement part only. Do not operate
the Hole Digger with the plastic protective cover plate
not properly installed or missing. Do not allow foreign
material to accumulate within the throttle control
assembly. Clean all throttle control components and
repair as necessary according to a regular
maintenance schedule.
5) An engine ON/OFF ignition switch that allows it to
perform its intended job function as outlined within this
manual. Replace any damaged engine ON/OFF
ignition switch with a factory approved replacement
part only.
6) Centrifugal clutch assembly in proper mechanical
condition that allows it to perform its intended job
function as outlined within this manual. Replace any
centrifugal clutch assembly with operational
characteristics that do not allow it to properly
disengage at the specific engine idle speed or properly
slip during overload conditions.
7) Each auger is in a structural condition that allows it
to perform its intended job function as outlined within
this manual. Bent auger axles should not exceed
established limits. Bent axles exceeding established
limits should be properly discarded.
8) Earth auger(s) has/have replaceable wear parts
(screw bit and blade) that allow(s) it/them to perform
its/their intended job function as outlined within this
manual. An auger with a screw bit and/or blade worn
past normal service life limits is not to be utilized under
any circumstances.
240H ONE MAN HOLE DIGGER
FORM GOM14081201, VERSION 1.1
16
To Next Page
Loading...
