18. Take the new grinder body complete with inner grinder ring from the
service kit. Screw the grinder body clockwise into the blade housing until
it stops.
Re-set the grinder blades. An approximate starting position is achieved by
turning the grinder body back one full turn anti-clockwise.
Re-assemble the grinder adjuster wheel assembly to the grinder unit.
19. Refit the fresh beans container to the machine. Pull the bean canister shut-
off to its fully extended position.
20. Turn on the electricity supply to the machine.
Important! Before returning the machine to service, the engineer must
carry out the Grinder Calibration routine described on page 42 to ensure
correct operation of the grinder with the type of beans used in the
machine.
Use the grinder adjuster wheel to fine tune the blade settings in order to
obtain the desired grind quality.
Technical Manual
133
To Next Page
Loading...
Need help?
General