14. Ensure that the cup drop mechanism operates correctly. Press the Cup
Test (button 7), located in the Service Keypad (see page 69) on the rear
of the door and ensure that a cup is ejected cleanly from the cup drop
unit.
15. Ensure that the dispense head mechanism operates correctly. Press the
Park Head (
button 8), located in the Service Keypad (see page 69) on the
rear of the door and ensure that the dispense head moves to its fully
extended position. Press the button again to return the dispense head to
its correct (homed) position.
16. Freshbrew Machines: Ensure the brewer guard and brewer waste
container are fitted correctly. Slide the container into position directly
under the brewer with its lip outside the brewer cover.
17. B2C Machines: Pull the bean canister shut-
off (a) to its fully extended position as
shown in the photograph.
Ensure that the brewer waste container is
fitted correctly beneath the CoEx® brewer
unit.
18. If fitted, check that the coin mechanism and cash box operate correctly.
Fill the coin tubes with correct coinage. Ensure coin return mechanism
functions correctly.
19. Operate the machine through its complete range of selections to ensure
that each vend is correctly dispensed. Follow the instructions for making a
vend using the Test Vend (
button 6) located on the Service Keypad (see
page 69).
20. Remove the safety key and close the cabinet door. Ensure that the
machine is left in a clean and safe condition.
21. Warranty card: Please complete and return the warranty card that
comes with the machine. Use the card to note any problems you
encountered during installation, your feedback helps us to improve our
products and services. Return the warranty card, whether problems were
encountered or not, failure to may invalidate your warranty.
Technical Manual
18
a
To Next Page
Loading...
Need help?
General