5
TABLE OF CONTENTS (CONTINUED)
Section Page
10 ELECTRICAL CONNECTIONS...........................................................................24
10.1 AC Line Input and Ground.....................................................................25
10.2 Motor and Ground ..................................................................................25
10.3 AC Line Input Fusing .............................................................................26
11 HIGH VOLTAGE DIELECTRIC WITHSTAND TEST (HI-POT)...........................27
12 TRIMPOT ADJUSTMENTS.................................................................................28
12.1 Minimum Speed Trimpot (MIN)..............................................................29
12.2 Maximum Speed Trimpot (MAX) ...........................................................29
12.3 Acceleration Trimpot (ACC) ..................................................................29
12.4 Deceleration Trimpot (DEC)...................................................................30
12.5 Slip Compensation Trimpot (COMP) ....................................................30
12.6 Current Limit Trimpot (CL).....................................................................31
13 DRIVE OPERATION............................................................................................32
13.1 Start-Up Procedure.................................................................................32
13.2 Fault Recovery........................................................................................32
13.3 Restarting the Drive After An Overload Fault Has Cleared ................33
14 DIAGNOSTIC INDICATORS ...............................................................................33
14.1 Illuminated On/Off AC Line Switch .......................................................34
14.2 Power On LED (PWR) .............................................................................34
14.3 Status LED (ST).......................................................................................34
LIMITED WARRANTY.................................................................................. Back Cover
Table Page
1 Electrical Ratings.................................................................................................9
2 General Performance Specifications .................................................................9
3 Factory Setting of Current Limit (CL) Trimpot ................................................13
4 Terminal Block TB1 Wire and Tightening Torque Specifications .................25
5 DC Hi-Pot Tester Setup Information.................................................................27
6 Fault Recovery and Resetting the Drive ..........................................................33
7 Operating Condition and Status LED Indicator ..............................................34
To Next Page
Loading...
Need help?
General