Genie IntelliG User Manual

Programming
Quick Reference Card
For detailed instructions refer to owner’s manual. 800-35-GENIE.
WARNING: DO NOT use wall console until limits have been set.
WARNING: Bullet MUST be engaged to carriage BEFORE setting limits.
Setting Limits & Remote Programming
for IntelliG
®
, TriloG
™
& GPower
™
Models
PROGRAM
SET
PROGRAM
SET
–
+
HOLD
2 seconds
HOLD
2 seconds
2
Press and hold the down arrow button (-) for
2 seconds until the long LED comes on blue
(round LED remains off).
PROGRAM
SET
–
+
3
Release down arrow button (-) and the long LED
will begin flashing.
PROGRAM
SET
–
+
PROGRAM
SET
–
+
HOLD
4
Press and hold the down arrow button (-) until
garage door is fully closed on floor, then release.
PROGRAM
SET
PROGRAM
SET
–
+
5
Press and release the Program Set button (both
LEDs flash blue and go off).
The down limit is now set.
Setting Down Limits: Setting Up Limits:
PROGRAM
SET
PROGRAM
SET
–
+
HOLD
2 seconds
HOLD
2 seconds
6
Press and hold the up arrow button (+) for
2 seconds until the long LED light comes on blue
(round LED remains off).
PROGRAM
SET
–
+
7
Release up arrow button (+) and the round LED
will begin flashing.
The up limit is now set.
PROGRAM
SET
PROGRAM
SET
–
+
9
Press and release the Program Set button (both
LEDs flash blue and go off).
PROGRAM
SET
–
+
PROGRAM
SET
–
+
HOLD
8
Press and hold the up arrow button (+) until door
is fully open, then release. Watch carriage as
it approaches the power head to avoid contact
with powerhead.
*If both LEDs turn RED at this time,
return to Step 1, Setting Down Limits.
P999-159 1M 1/13 JAR

Genie IntelliG Specifications

General

Lighting	Built-in LED light
Voltage	120V
Smart Home Compatibility	Compatible with Aladdin Connect
Remote Control	Included
Number of Remotes Included	1
Security	Rolling code technology
Motor Power	1/2 HP
Horsepower	1/2 HP

Summary

Setting Down Limits

Down Limit Setting Procedure

Steps involve holding the down arrow button, releasing it, closing the door, and setting the limit.

Setting Up Limits

Up Limit Setting Procedure

Steps involve holding the up arrow button, releasing it, opening the door, and setting the limit.

Setting Force and Speed

Force and Speed Adjustment

Procedure to set the force and speed of the garage door opener by operating the door.

Programming Remotes

Remote Programming Steps

Instructions for pairing a remote control with the garage door opener system.

Clearing Remote Memory

Procedure to erase all previously programmed remote controls from the power head.