Need help?Do you have a question about the Genie IS and is the answer not in the manual?
General| Type | Chain Drive |
|---|---|
| Horsepower | 1/2 HP |
| Battery Backup | No |
| Voltage | 120V |
| Security | Rolling Code |
Checks the ceiling for proper mounting location of the power head unit.
Verifies the wall directly above the garage door provides a strong mounting location.
Ensures the STB mounting location is clear and has wood surface for brackets.
Addresses additional support bracing needed for light-weight doors.
Confirms availability of a 110-120 Volt power supply near the operator.
Advises disabling any door locks before installing the operator.
Ensures the garage door is properly balanced and moves freely.
Critical warnings about using extension cords or portable generators.
Details placement and fastening of sensor and source brackets.
Covers installing the beam emitter (source) and receiver (sensor).
Explains routing and securely fastening the STB system wires.
Routine checks, lubrication, and door balance testing.
Annual lubrication requirements for the drive screw.
Guides for diagnosing Safe-T-Beam system issues using LED indicators.
To Next Page
