English
-14
built-in memory is full, will flash; will be displayed if the built-in memory is
empty.
Ú When the camera’s SD or MMC memory card is in use,
will be displayed.
When the memory card is full,
will flash; will be displayed if the memory
card is empty.
Removing the SD card while taking or viewing your images can damage the SD card
and cause the camera to malfunction.
This product accepts SD memory cards of sizes between 32MB to 1GB.
The memory card will not slide fully into its slot if it is incorrectly inserted. Do not apply
excessive force when inserting the memory card to prevent causing damage.
If the camera is unable to read the memory card, please use a soft and dry cloth to
gently wipe the gold contacts on the card, before re-inserting.
If the SD is new, please use the camera’s Format feature to format it before using.
Turning on for the first time
Slide the power cover sideways as shown in the picture to switch the camera on.
Slide the power cover sideways as shown to switch the camera off.
Slide the power cover on the top of the camera sideways to start-up, Switch the power
on and off. When the camera is switched on, the red indicator light will flash, an image
will appear on the LCD display.
Ú This camera comes with three power saving options: Off, 1 minute, 3 minutes. If the
camera remains on and inactive throughout the preset power saving period, the
camera will automatically switch off. To switch it on again, slide the power cover in
the “off” and “on” directions successively.
Ú The following functions, irregardless of whether they are switched off manually or
automatically, will retain the last settings before the camera was turned off, unless
reset to factory settings at “Setup mode”:
1. Resolution, 2. Image quality, 3. Language setting, 4. White balance, 5.EV,
6.Frequency, 7. PC connection mode.
To Next Page
Loading...
