SmartObserver User Manual
SmartObserver Data Logger
No-charge temperature
This is the minimum temperature for charging the battery. When the environment temperature is
lower, the battery will not be charged in order to prevent battery damage. Typically, this value should
be between -10 °C and -30 °C, depending on the battery type. Please check the battery data sheet
to congure the correct value.
Enable charge
Enable or disable battery charging. In normal operation mode, this parameter should be set to
Enable.
Input And Output Settings
Send alert on GPIO
Enable this parameter to start monitoring signal change on digital inputs. Whenever the change in the
digital input is detected, the data logger will connect to the server and send an alert. If digital inputs are
not used, set this parameter to Do not send alert.
To Next Page
Loading...