GeoMax EZiSYSTEM i Series User Manual

108EZiSYSTEM, Functional Checks
A.2 Transmitter Functional Check
Checking the function The purpose of the following procedure is to verify the performance of the signal Trans-
mitter.
Before any tests can be carried out it is vital to check the status of the unit, its batteries and
basic functionality.
To carry out this test the following are required:
• The Transmitters cable Set.
• A fully charged battery pack.
1. Inspection
Once the general condition of the Transmitter is established the Audio Visual test can be
performed.
•Casing The casing should be free of significant damage.
•Cable Set The cable set should be free of damage to the cable's insula-
tion and clip shrouds.
The terminals should be free of corrosion.
• Labels Body labels must be legible and intact. Display label must be
free of damage and tears.
• Battery hatch The hatch must lock into place.
• Battery holder All the battery contacts and springs on the holder must be free
of corrosion and the holder in good condition.
• Battery contacts The battery contacts must be free of corrosion.

GeoMax EZiSYSTEM i Series Specifications

General

Brand	GeoMax
Model	EZiSYSTEM i Series
Category	Security Sensors
Language	English