16EZiSYSTEM, How to Use the Locator
2.3 Locator Setup and Information
Locator settings The i-Series Locators offer a range of settings which the operator can adjust to their own
preference. It also displays additional service and contact information as detailed.
Setting Description
EST Performs a function check on the locators hardware and software,
displaying PAS if the Locator is within predefined tolerance or
ERR if the locator is not.
H.Z Switches hazard zone on or off.
VOL Adjust volume level (0 - 10).
HLD Adjust peak hold duration (0 - 5 seconds).
SSI Displays a numeric signal strength indicator.
CST Adjusts display’s contrast (0 - 15).
M/I Displays unit of measurement.
CAL Displays the next service date DD/MM/YY.
CON Displays supplier/company name.
TEL Displays supplier/company telephone number.
I.D Displays the operator’s name.
PWR Displays the power mode regional setting. Refer to "Appendix B
World Frequency Zones" for more information.
SR# Displays unit serial number.
VER Displays software version.
CLK
(i600, i650, i700, i750,
i600xf, i650xf, i750xf)
Displays the date and time held within the locators memory.
Format DD/MM/YY/HH/MM/SS.
To Next Page
Loading...
Need help?
General
