44
45
EnglishEnglish
Track
TRACK
The Track function allows recording the track actually fol-
lowed by the boat. The Track function can be enabled and
disabled several times during navigation.
Starting a track
To enable the Track function, press the PAGE key to display
the menu bar, select TRACK, START and press ENTER to con-
firm. A small circle on the boat’s position will indicate the
track starting point.
Stopping a track
To disable the Track function, press the PAGE key to display
the menu bar, select TRACK, STOP and press ENTER to con-
firm.
Storing a track in the CompactFlash™
Press the PAGE key to display the menu bar, select TRACK,
STORE and press ENTER to confirm. To change the default file
name and confirm the operation, use the CURSOR key.
The “TRACK STORED” message will confirm that the track
has been stored correctly. Once stored, the track will disap-
pear from the screen.
Each time a track is stored in the CompactFlash™, the plotter’s
memory is cleared and the indicator of memory used in the
TRACK menu is reset to 0%.
Recalling a track from the CompactFlash™
Press the PAGE key to display the menu bar, select TRACK and
then RECALL to open the track catalog.
Select the track desired, then press ENTER to confirm the op-
eration or PAGE to exit.
Reversing a route
Press the PAGE key to display the menu, select ROUTE and
then REVERSE (if no route is currently displayed, the “NO
ROUTE PRESENT” message is displayed).
The waypoint order will be automatically reversed allowing
navigation in the opposite direction. To display information
on the new route, select the ROUTE/INFO option.
Route
To Next Page
Loading...
