11
2.2.2 Top, Left-Side and Right-Side Views
No. Name Function
1
Micro SD Card
Slot
Connect to a micro SD card for local storage of content and firmware
upgrade.
2 LED Indicators
The red LED indicates the power is supplied. The green LED indicates
the system is ready.
3 Stand By
Press to enter the Standby/Sleep mode. In the standby mode, the
screen turns off to minimize power consumption. Press the key again
to enter the ON mode.
4 Power Off/On Switch the power on or off.
5 DC 12V Connect to power using the supplied power adapter.
6 USB
Connect to a GV-Joystick V2, USB mouse, or USB storage device for
local storage of content and firmware upgrade.
7 Line Out Port Connect to a headphone or speaker.
8 Default
Reset the device to the default settings. Use a pin to press the default
button for about 5 to 10 seconds. The system will then reset and
reboot itself shortly. See 5.2 Restoring Default Settings.
To Next Page
Loading...
