Gerber EDGE FX Installation Guide

7
To unpack the GERBER EDGE FX
WARNING: The GERBER EDGE FX weighs 84 pounds and requires two people to
lift it.
1 Carefully open the shipping carton.
2 Open the plastic bag and remove the protective foam from the top of the unit. Save the
foam packaging materials.
3 Using the contents list on page 6, verify that the contents of the carton and the
accessories box are present and not damaged.
4 Remove and unpack the accessory box. Set aside its contents for later use.
5 Using two people, one on each side of the printer, carefully lift the GERBER EDGE FX
printer from the box using the cardboard sling and set it on a table.
6 Lift the GERBER EDGE FX off of the cardboard sling and save the sling for future use.
Protective foam
packaging
Protective foam
packaging

Gerber EDGE FX Specifications

General

Print Technology	Thermal transfer
Resolution	300 dpi
Connectivity	Parallel
Media Types	Vinyl, Reflective
Max Media Width	15 in (381 mm)
Max Print Width	11.8 in (300 mm)