3.2 MAP Requirements
3-2
Monitoring the Network Interface Board
sysadm
.
3.2 MAP Requirements
To use MAP, your workstation must have the following installed:
• Microsoft TCP/IP protocol
It is not necessary for the network to support TCP/IP. However, the TCP/IP
protocol must be installed even if the network does not support it.
• A Web browser — such as Internet Explorer or Netscape Navigator
• IPX — if you want to use the IPX search functions
Both the Microsoft standard stacks and Novell 32-bit stacks are supported.
3.3 Installing MAP
You can install MAP on any workstation hard drive or network drive.
To inst al l M AP:
1.
Put the supplied CD-ROM into the CD drive of your workstation.
2.
Choose
Start
>
Run
.
3.
Type the following command and click
OK
:
drive
:\MAP\SETUP.EXE
where
drive
is your CD drive.
4.
Read the information in the MAP installation notes.
5.
At the prompt “Do you wish to install MAP?,” click
Yes
.
6.
Select a destination directory for the program (default is
C:\Program Files\MAP
) and click
Next
.
7.
Select a program folder (default is MAP) and click
Next
.
Note:
You cannot use MAP with Windows 3.1.
To Next Page
Loading...
