Gestetner 1502 - Checking Assignments; Setting up and Resetting the Printer; Configuring the Network Interface Board

4.4 Configuring the Network Interface Board
4-12
NetWare Configuration
5.
Click
OK
.
4.3.6 Checking Assignments
1.
In NWADMIN, choose
Object
->
Browse
.
2.
In the NWADMIN directory tree, double-click the print queue object.
The Print Queue window opens.
3.
Click
Assignments
.
If you configured the print queue and printer correctly, they will appear in the
proper boxes in the Print Queue window.
4.
Click
Cancel
.
4.3.7 Setting Up and Resetting the Printer
After completing the NWADMIN configuration, you must set up and reset (power cycle)
the printer before you can begin printing.
4.4 Configuring the Network Interface Board
Use the MAP utility or a Web browser to:
• Define the context and tree of the Print Server
• Change the Print Server name
• Set a password
• Set values for Bindery Mode
For more information, see Chapter 3,
Monitoring the Network Interface Board
.
To configure the Network Interface Board:
1.
Access the setup pages for the Network Interface Board using MAP or a Web
browser.
2.
Once you have accessed the Network Administration pages or the Main Menu,
choose
Setup NetWare
under
Protocols
.
3.
Confirm that there is a check mark in the
Enable NetWare
option. If necessary,
put a checkmark in that option.
4.
Optionally, enter a name in the
Print Server Name
field.
To use the default name, leave the field blank.