4.6 Configuring NetWare and Print Servers Using NWSetup
4-24
NetWare Configuration
4.6.5 Configuring the Notify Settings
To configure the Notify function for the users or group, double-click an entry in the
Users/
Groups Notified by Printer
field on the Print Server screen. The Notify Settings screen
appears with the following options.
NDS Context Specifies the NDS context to use when generating a list of
users and/or groups. This field is enabled only for NDS
connections. When first displayed, this field lists the
preferred NDS context specified in the Print Server Settings
screen. If you change this value, NWSetup verifies that it is
correct when you attempt to move to another field or when
you click
OK
.
Users/Groups Lists all the users and groups available on the selected
connection. Any entry on this list can be added to a
printer’s service list. The list includes print job owner (the
user whose job is currently being printed).
• If an NDS connection is selected, NWSetup generates a
list of all users and groups in the currently selected
context and all subcontexts.
• When you double-click an entry in the list, the entry is
added to the printer’s service list.
• The user/group list is updated whenever the
Connection
or
NDS Contex
t field is changed.
Delay in seconds for
first
Indicates how long the Network Interface Board should
wait before sending a notification message that an error
condition has been detected.
Delay in seconds for
repeat
Indicates how long the Network Interface Board should
wait before sending a repeat notification of an error
condition.
Note:
The Network Interface Board supports Notify in
Bindery Mode only.
Field Description
To Next Page
Loading...
