Gestetner 1502 - Selecting a Print Server; Configuring the Network Interface Board for Netware

4.6 Configuring NetWare and Print Servers Using NWSetup
NetWare Configuration
4-17
Note:
If you are configuring for NDS, make sure you are logged in to the correct tree and
context before running NWSetup.
4.6.2 Selecting a Print Server
NWSetup displays a list of all NICs available on your network. Each NIC is listed with its
serial number.
Note:
NWSetup allows configuration of NICs that are connected to the same context of your
NetWare server as the workstation running NWSetup.
To choose the NIC you want to configure, do either of the following:
• Highlight the NIC you want and click
Select
.
• Double-click the NIC you want.
The Print Server Settings screen appears. This screen lets you set up your version of
NetWare for the NIC.
4.6.3 Configuring the Network Interface Board for NetWare
There are two Settings screens that you need to complete to configure the Network
Interface Board for NetWare, including Directory and Bindery Services.
The following table describes the fields on the Settings screens.
Field Description
Print Server
Name
Indicates the NetWare print server name that the Network
Interface Board uses to log in to NetWare. You can enter any
name that does not already exist in the network directory or
server bindery.
The maximum length is 48 characters.