Gestetner 1502 - Internet Printing Protocol (IPP) Printing; Setting up a Printer Using IPP; Setting up the IPP Functions of the Printer

7.8 Internet Printing Protocol (IPP) Printing
TCP/IP Configuration
7-17
2.
Choose an exiting option and press
Enter
.
7.8 Internet Printing Protocol (IPP) Printing
7.8.1 Setting Up a Printer Using IPP
You can use the IPP with Windows 2000.
To set up a printer for IPP printing:
1.
Assign an IP address to your print server.
2.
Reset the print server.
3.
Use the
ping
command to make sure the print server responds.
7.8.2 Setting Up the IPP Functions of the Printer
You can set up the IPP functions of the printer by using MAP or a Web browser. For IPP
printing, your workstation must have an IPP client installed (either from Microsoft or a
third-party).
To configure the printer for printing:
1.
Choose
Start
->
Settings
->
Printers
.
2.
Click
Add Printer
.
The Add Printer wizard appears. Click
Next
to proceed.
3.
Choose the
Network Printer
option and click
Next
.
4.
On the Locate Your Printer screen, select
Connect to a printer on the Internet
or on your intranet
and type the correct printer path. (case sensitive)
The format is:
URL: http:// ip-addr :631/Print
where
ip-addr
is the IP address of the printer. For example:
URL: http://199.92.186.97:631/Print
Note:
Your printer port number is listed on the NIB Status Page next to the Internet Printing
Protocol.
5.
Click
Next
and finish printer setup.
For example, select the appropriate printer type.
6.
Perform a Test Print from your printer and check the printer for the test page.