EasyManuals Logo

GESTRA LRGT 17-1 Installation & Operating Instructions

Default Icon
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
27
Removing and disposing of the conductivity transmitter
Removing and disposing of conductivity transmitters LRGT 16-1, LRGT 16-2, LRGT 17-1
1. Switch off the supply voltage.
2. Unscrew the cover screws f and remove the housing cover g.
3. Disconnect the connecting wires from terminal strip n and pull wires out of the cable gland.
4. Make sure the equipment is not hot or under pressure before dismantling it.
Dispose of the conductivity transmitter in accordance with statutory waste disposal provisions.
Maintenance
Danger
Take care not to bend the electrode rod(s), and prevent hard physical shocks to the rod(s).
Note
After cleaning the electrode rod(s), the conductivity transmitter should indicate the correct
conductivity once more, without any changes to settings. It is only necessary to adjust the
cell constant in isolated cases.
continued

Table of Contents

Other manuals for GESTRA LRGT 17-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GESTRA LRGT 17-1 and is the answer not in the manual?

GESTRA LRGT 17-1 Specifications

General IconGeneral
BrandGESTRA
ModelLRGT 17-1
CategoryController
LanguageEnglish

Related product manuals