10
Installation instructionsDecomat 4656
9809
Functional check
• Ensure that the machine is connected to the correct power supply and that the
drain, water, steam and condensate connections are correctly made. Open the
water and steam cocks.
• Fill the detergent and rinsing agent bottles and place their level alarms in the
bottles.
• Place any accessories required in the washing chamber and close the door.
• Choose a program in which dosing is made from each of the detergent and
rinse-aid bottles and start the machine (see Operating Instructions).
• Ensure that filling with water in the machine is satisfactory.
Note.
The circulation pump must be filled with water. The axial seal
may be damaged if there is no water in the pump.
• Ensure that the circulation pump is rotating in the right direction as indicated
by the arrow on the pump motor. If not, break the power supply, change the
phase sequense and restart the machine.
Fig 9. Circulation pump
• Ensure that the dispenser pumps operate at the correct time in accordance
with the description of the program in the Operating Instructions and that
detergent is supplied.
• Check while the program is running that the door/doors cannot be opened.
• On machines with double doors, check the door locking function on
completion of a program as follows:
- Ensure that the door on the soiled side cannot be opened.
- Open the door on the clean side and then close it again.
- Open the door on the soiled side.
- Check that the door on the clean side cannot be opened.
• Ensure that there is no leakage of water or steam. Re-tighten connections for
water, steam and drainage if required.
V171
To Next Page
Loading...
Need help?
General
