To Next Page

To Previous Page

CONTROL PANEL

Layout of the control panel

1. PROGRAM SELECTOR button –

selection of the program

2. START button – start of the program

3. RESET button – reset a fault

4. STOP button – emergency stop

5. Yellow status lamp – program in progress

6. Green status lamp – program finished

7. Red status lamp – alarm

8. ENTER button – select items from the menu

9. Arrow keys – navigate through menus/lists

10. Pressure gauge – shows the chamber pressure

11. Display unit

Display unit

Shows the current status, program progress, number of minutes after program start, number of completed

cycles and error codes.

IN STANDBY MODE SHOWS:

• Process name (program)

• Sterile time/temperature

Press the DOWN arrow to CYCLE COUNTER (twice)

and then press the ENTER button now press the

DOWN arrow to read the pressure and load sen-

sor temperature (when the sterilizer features a

liquid program).

SHOWN DURING THE PROCESS:

• Process name

• Process time,

Home position:

Press the LEFT arrow for at least 4 seconds

To specifically read the load sensor temperature

(when the sterilizer features a liquid program),

press the ENTER button at the process name.

Getinge VS60 User Manual

Questions and Answers: