ECdrive H
4
Safety instructions
à Observe the latest versions of guidelines, standards and country-specic regulations, in particular:
à EN16005 “Power operated pedestrian doorsets - Safety in use - Requirements and test methods”
à DIN 18650 “Building hardware - Powered pedestrian doors”
à VDE 0100; Part 610 “Erection of low-voltage installations”
à DIN EN 60335-2-103
à Accident-prevention regulations, especially BGV A1 "Principles of prevention" and BGV A2 “Electrical sys-
tems and equipment”
3.3 Safety conscious working
à Secure workplace against unauthorised entry.
à Watch pivoting range of long system parts.
à Never carry out work with a high safety risk (e.g. installing the drive, cover or door leaf) while alone.
à Secure the cover/drive panels against falling.
à Use only cables prescribed in the cable plan provided. Lay shields in accordance with the wiring diagram.
à Secure loose, internal drive cables with cable ties.
à Before working on the electrical system:
à Disconnect the drive from the 230 V mains and check to ensure that it is not supplied with power.
à Disconnect the control unit from the 24 V battery.
à Note that if an uninterruptible power supply (UPS) is used, the system will still be supplied with power
despite the fact that the power supply is disconnected.
à Always use insulated wire-end ferrules for wire cores.
à Attach safety stickers to glass door leaves.
à Danger of injury with opened drive. Hair, clothing, cables, etc. can be drawn in by rotating parts!
à Danger of injury through unsecured crushing, impact, drawing-in or shearing spots!
à Danger of injury by broken glass!
à Danger of injury due to sharp edges in the drive!
à Danger of injury during installation through freely moving parts!
3.4 Inspection of the installed system
Measures for security and prevention of pinching, impact, shearing or drawing-in spots:
à Check the functioning of safety sensors and movement detectors.
à Check protective earth connection to all metal parts that can be touched.
à Perform a safety analysis (risk analysis).
3.5 Environmentally conscious working
à When disposing of the door system, separate the dierent materials and have them recycled.
à Do not dispose of batteries and storage cells with household waste.
à Comply with the statutory regulations when disposing of the door system and the batteries/storage cells.
To Next Page
Loading...
Need help?
General
